Symptom: An M2700 machine encountered scanning failure during the operation of scanning folders, with the display screen reporting a "server response error". Possible causes of malfunction analysis: 1. SMB protocol in the Windows system of the user's computer ..
MP2014 series and M2701, M2700 models in different domestic operating systems to install printing methods, so the series models only adapt to the AMD64 architecture of domestic operating systems, do not support other architectures of domestic operating systems...
During the printing process of the machine, there was a sudden image loss. The developing paper card was checked and there was no image at the back of the toner cartridge. After removing the toner cartridge, the laser was unobstructed. Upon disassembling the toner cartridge, it was found that one end of the charging and cleaning roller had fallen off: it was caused by a broken slot. The problem was resolved after replacement. . .....
How to repair the slight and unclear width of a few centimeters in the middle of the Ricoh IM2700 photocopy manuscript? Ricoh/Kiester, Ricoh copier repair ..
Symptoms: When an MP2701 machine selects to copy, it is ready. The paper tray light is on and out of paper, but there is paper in the standard paper tray. Reason: 1) The paper is used up. The sensor is bad or falls off. 2) The detection contact rod is stuck, resulting in the wrong sensor signal...
After pulling out the Ricoh IM2700 paper box, there is a prompt T1 to turn it off. It is normal to turn it off and then back on. As long as the paper box is pulled out and closed once, it will prompt a paper shortage, report T1, replace the upper limit sensor, the fault still persists, replace the motherboard, and finally replace the paper box ..
Symptom: After turning on the machine, it displays "Reduce the paper in the tray to the limit mark or reset correctly", and the machine cannot be used. The fault is shown in the following figure: Diagnosis process 1) The paper placed in the paper box does not exceed the upper limit mark. Check the position of the paper lifting motor at the back of the paper box ..
Symptom: The image of an M 2701 machine is incomplete when copying using a document feeder. Repair process: 1. Copying images using the draft table method is normal; 2. The size detection of the original manuscript in this model's document feeder is carried out by: original manuscript width sensor - detecting width; ...
Symptom M2701: When copying on the glass of the original manuscript table, the image is parallel to the sub scanning direction, with a black stripe of about 1cm along the edge of the tip. The scanning and copying phenomenon of A3 and A4 originals is the same. Check that the image is not skewed, and the magnification is not enlarged or reduced ..
Symptom: SC350-00 startup report Analysis: The manual states that SC350-00 ID sensor (S6) error (detailed) is only for factory use. During ID sensor detection, one of the following situations occurs (only when SP5-...)