1.1 Required: Replace SP to prevent PTB side seal from peeling symptoms PTB side seal peeling, resulting in dirty output back or damage to PTB. reasons in order to remove the ptb cleaning part of the scraps of paper and/or waste...
Symptom: Frequent paper jam at the paper outlet of the machine's fixing machine, as shown in the following figure: Reason: Poor fixing paper sensor; Repair process for poor peeling guide plate at the fixed paper outlet: 1. Check the machine's paper jam position record, and the main paper jam record is fixed .....
The problem of condensation on the drum surface and charging. Reason: After half a year of use, the 8320's printed files turned white when turned on in the morning, and the drum was replaced, charged, rotated, and biased, but none of these issues were resolved. Solution: On site printing testing confirms and reflects issues ..
In double-sided printing with reverse side fixing, when the paper enters the fixing gap, the front image may curl * 1 due to feeding, causing the paper to lift slightly. The tail end of the paper contacts the fixing belt, resulting in uneven gloss. *The front of the paper is curled, and the back is printed on both sides ..
Symptoms: When the machine copies or prints, there is often a failure of irregular creases in the sub-scanning direction, and the creases are not fixed. Analysis of the possible causes of the failure: 1. The paper is not transported well in the machine. 2. Poor paper quality. measures: 1. replacement...
Symptom: The machine is rattling during operation. It is preliminarily judged that the noise emitted by the operation of mechanical parts is not electrical noise. Analysis of causes: There are many parts that may generate noise when the machine is running, which can be checked by parts and components. 5-80...
I received a description from the previous supplier that the IGBT gate fuse was broken and replaced, but the fault still persists. Therefore, they sent it to our center for repair. Due to a faulty insurance, the IGBT was mistakenly short circuited during testing, but the test results were unexpectedly completely normal. Later on ..
Repair process: Replace the fixing unit to test the fault, replace the BCU board to test the fault, replace the power board to test the fault, unplug the * CU board from the fixing unit to test the fault, and finally remove the connection harness from the BCU board to the fixing unit for use ..